|
Central Iowa | Trying to get a 612c corn head set on an S680. There are three sensors on the header, left center right that use the guide bar under the row dividers to follow contour of the ground. My head continuously leans to the right a bit, even on level ground. Stalks on the left side are cut a tad higher than the right. I have run the AHC calibration process a couple different times.
Below is pic taken while operating and does show the left higher than the right which should push the head higher to the left. I can't remember, can i physically adjust the sensors under the head to account for this and "even" it up, or can i calibrate something in the control system.
Edited by IState 9/10/2024 22:58
 (612 (full).jpg)
Attachments
----------------
 612 (full).jpg (143KB - 1 downloads)
| |
|
Deere 612c header height control sensors---head leans to right
