|
Central IL | I’ve attached a pic of what my node is showing. It says boom or cal with a cross through it and it’s blocking where actual applied rate would be. This is a new to me node, I’ve seen this occasionally on my other nodes but if I go to another page and come back it’s usually gone. Can’t get it to go away with this one. Boom width, meter cal, and fast close numbers are all programmed as well. What am I missing?
Edit to add: my strip tiller flow meter number is 171 for pounds of N, the node asks for pulses per 10lbs of N. Do I just put in the 171, or multiply by 10?
Edited by Case IH Farmer 12 11/18/2024 08:02
 (IMG_8322 (full).jpeg)
Attachments
----------------
 IMG_8322 (full).jpeg (78KB - 6 downloads)
| |
|
Raven node question
