|
| if a power beyond block is adding between the number 1 scv and transmission, I should be able to run a hydraulic flow line out of one port, through the motor I want to drive and back into the port on the side of the block for the return. If none of the SCV's are activated there is no signal pressure going back to the pump to tell the pump to generate more flow/pressure to continue driving the motor at the same speed when it is loaded. If a power beyond is used, is there another line that needs to be added as a signal to the pump? I assume this is the load sense I read about, but not quite figuring out where a load sense line is plumbed in at both the motor or the tractor transmission. Any help. I know this is super basic stuff but I'm not much of a mechanic. | |
|
basic power beyond question for a deere 4640
